RESERVED for Vicky.  Thank you!

A set of DIY supplies to make your own one-of-a-kind dollhouse lamps.  It is sold as is, customization not available at the moment.

You may make wired table or floor lamps with these components and then stow away the battery pack behind the couch or any inconspicuous area in your mini scene. 

I'd recommend soldering the wire connections for longer lasting joints.  However, if you prefer to simply twist the wires and secure them with heat shrink tubes, they will work too.  If and when the joints become loose, just reconnect with the extra heat shrink tubes.

Though you will receive printed instructions, I've included a photo on some of the steps and hope that will help.

Each set contains:

1 wired 3-volt LED bulb - white wire length approximately14", LED diameter 5.5mm at the widest section.   For a table lamp, you probably won't need all the length and may cut the wires to your preference.

1 battery pack / holder with on/off switch

heat shrink tubes (2 sizes for a total 9 inches so you may cut the needed length yourself and save some for future use / repair)

1 CR2032 coin cell battery

printed instructions on how to connect the LED wires to the battery pack

---------------------------

Tools needed:

A tool to shrink the platic tubings.  Recommended: a heat gun.  Alternatives: powerful hair dryer or cigarette lighter if you want.  Disclaimer: I haven't used cigarette lighter for this purpose but did see successful application on Youtube.

A tool to strip the plastic sheathings on the wires.  Recommended: a wire stripper or utility knife if you are dexterous

If you've any questions about the tools, please DM me on Instagram.  My IG account name is: @petitewonders28_miniatures